• Please do not post any links until you have 3 posts as they will automatically be rejected to prevent SPAM. Many words are also blocked due to being used in SPAM Messages. Thanks!

Recent content by lcdguy

  1. lcdguy

    Mystery ethernet outlet in house

    likely a phone jack, though the cable they used in the wall might actually be ethernet (ie: 1 cable for 2 phone jacks) though probably a much older standard than cat6. Jack also might be an rj45 just not terminated on more than the 2 wires per port
  2. lcdguy

    the telescope, spotting scope, monoscope & binocular optics discussion thread

    yup when i wanted to get a scope a number of years ago i went with a 6" Newtonian reflector (sky watcher i think) on an equatorial mount. It was reasonably priced and has served me well over the years.
  3. lcdguy

    3D Printer / CNC discussion thread

    yeah it was one problem i had continually when i had an ender 3 with the free wheeling side of the gantry getting out of alignment. I eventually completely removed them from the non drive side.
  4. lcdguy

    3D Printer / CNC discussion thread

    yeah, i would say if you want to convert the ender 3 to a direct drive a dual z axis upgrade or additional stiffening/strengthening of the x axis gantry should probably be considered first.
  5. lcdguy

    3D Printer / CNC discussion thread

    that's an interesting concept. In the case of the ender 3 since it's a cantilever design i would be concerned with the added weight of the bracket and stepper when the extruder is fully extended on the X axis. Additional stiffening or dual z axis might be needed to ensure print reliability. I...
  6. lcdguy

    3D Printer / CNC discussion thread

    not sure what issue you are trying solve. I have heard from other people with bowden setups that swapping out the stock ptfe bowden tube and connectors with a higher grade one like from Capricorn have yielded good results or possibly investigate the possibility of switching the ender 5 from a...
  7. lcdguy

    Which space sim is left?

    yup i agree it is really unfortunate.
  8. lcdguy

    Which space sim is left?

    yeah i know what your mean, i have logged waaaay to many ly's in elite. I also enjoy the occasional jaunt through fs2. I recently picked up everspace which is interesting but not really a hotas affair. I think it supports it but is better played with a mouse. could always look at (shudders)...
  9. lcdguy

    Which space sim is left?

    there is always freespace and freespace 2 if your feeling nostalgic, though not sure if it works with throttles or not.
  10. lcdguy

    Want to Buy [FOUND] Thrustmaster Warthog throttle only? Or set depending on price

    i have been rocking some CH Products gear but they are a bit quirky at times. Virpil is nice but it's a lbit of a lottery to get your hands on them. I think VKB has some nice products as well i believe. Looks like there is a restock at 6AM GMT on the 25th.
  11. lcdguy

    Which space sim is left?

    lol, yeah i don't see a point to Fleet carriers other than a massive credit sink.
  12. lcdguy

    any Ubiquiti UniFi guru's here?

    probably will need screen shots then of the usg config from your controller. Also are you using an vlan's on your network.
  13. lcdguy

    any Ubiquiti UniFi guru's here?

    also i assume you have already made sure you aren't connecting the switch to the console port of "voip" port on the usg. Also make sure you are configuring your wan port on the usg with the same settings as the dlink router that works.

Latest posts

Twitter

Top