What's new
  • Please do not post any links until you have 3 posts as they will automatically be rejected to prevent SPAM. Many words are also blocked due to being used in SPAM Messages. Thanks!

Primochill Ghost Fittings

JD

Moderator
Staff member
Joined
Jul 16, 2007
Messages
8,910
Location
Toronto, ON
Just a heads up...

I don't know what happened, but it doesn't seem to make a good seal on my XSPC top anymore. It was leaking everywhere today. Even once I got the tubing off, the fitting itself was still nice and tight and I had to use pliers to remove it.

Anyways I rammed a 1/2" D-TEK barb into my 3/8" tubing and I'm using that on my pump now. Though it's rather unsafe since the tubing is only on the tip and not fully covering the entire barb however seeing how tight it is I doubt it'll be a problem. Least it's not leaking though.

Of course doing this made a mess of Feser all over the place, so now I got to let my PC dry out for a good 24 hours just to be safe.

Guess I'll be getting those Bitspower compression fittings I wanted...
 

Mibs

Well-known member
Joined
Jun 5, 2007
Messages
311
Location
St. John's, NL
Just a tip, using contact cleaner on your board and other components is a good way to get the Feser one off once it dries. That stuff tends to leave a pretty sticky residue on things it gets spilled on.
 

JD

Moderator
Staff member
Joined
Jul 16, 2007
Messages
8,910
Location
Toronto, ON
Just a tip, using contact cleaner on your board and other components is a good way to get the Feser one off once it dries. That stuff tends to leave a pretty sticky residue on things it gets spilled on.
Well I caught it pretty quickly so it didn't hit any PCB to my knowledge. Just got on my cables and fans. I'll be sure to check thoroughly though. Don't have any contact cleaner on had so isopropyl alcohol will have to do I hope.
 

Latest posts

Twitter

Top