How did you plan the hole placement for the wires? eye balled it? cardboard mockup?
The PSU ones don't really matter. I wanted them offset from the connectors on the motherboard. But for the wires running underneath the motherboard I did measure.
looking great! the texture that the 3d printing process leaves works great for your case. is there a finishing process you are doing to the pieces after printing or is it mostly raw? looking forward to some photos of the overall case when you finish.
You can probably count my sanding time in days not hours. I sand w/ 80 grit over and over to eliminate most of the lines from 3d printing. Some of the edges of a part may not have been sanded as well if I could affect the fitment.
The 'front panel' USB-C, power button cable, and 3 x 180mm fan control wires run underneath the motherboard.
And in to the little box behind the PSU.
Installed the board in the case so I can finish sleeving. My dead board I was using doesn't have the connections in the right place so it can't be used to finish sleeving. I decided to ditch my ol' Noctua NH-D14 w/ a B Quiet Black Rock Pro 4 as it looks cool.
And a rather big set back. Expansion cards don't fit lol. I'm going to have to pull everything out and sand where you screw in the cards at least a full mm.