Gallery Fuzzy's Core P5

[Father Fuzzy]

Transferred rig from a corsair 650D to the Thermaltake Core P5

Asus Maximus 4 Extreme with 3570K

Corsair AX1200 PSU

16 gig Corsair Dominators

Intel 520 ssd's

WD Black 750 gig 2.5 hard drive

AMD 6970 GPU with Koolance block

XSPC RX 480 rad

55mm trieberks fans with admiral fan shrouds

aqua computer Aqualis res with waterfall

Black Primochill acrylic tubing 3/8-1/2

ghost/revolver fittings

fun with tubing

Used a laser level to help with the measurements

ran out of black tube so used a blue piece for practice

Had to find some threaded rods to make some custom bolts to use the fan shrouds

Added a hot swap bay on the side of the case using a Caselabs 5.25 bay adapter to 3.5

 

[GrinderCAN]

Nice work as usual FF. But clean that poor GPU block! :biggrin:

 

[Father Fuzzy]

Thanks Grinder

I did clean it eventually

putting 2 led's in the fan shrouds looked ok but made a wiring nightmare beside the res

installed nzxt 2 metre led strip weaved into the fans

found a switch for controlling some of the lighting....Wallee

Changed over the black ghost fittings for some red anodised revolvers I picked up from HWC member Ballistix

shot of the thermaltake logo with under mobo lighting was quickly removed with some acetone

trying out some lighting on acrylic under himuru

 

[lowfat]

Very nice bends. :thumb:

 

[Jokester]

great tube work. The black on red fittings really makes it.

 

[Father Fuzzy]

Very nice bends. :thumb:

thank you sir!

great tube work. The black on red fittings really makes it.

thanks Jokester the red fittings was a nice improvement

8 pin connector was a little too tight so I sleeved an extension

Wall mounted

A quick video of the waterfall effect

https://youtu.be/lQg-Y8VVkbc

Few more little things to do but its getting close

 

[tehpr0fess0r]

Damn, those black tubes look sweet! Makes me want to build another PC just so I can use some of those.

Is the waterfall effect audible? It would drive me nuts to hear water dripping all the time